Omron K35-2, User Manual

Page: 90 / 186

Functions and Oper
ations
Section 5 Functions and Operations
5-28
5.5 Setting Prescale Values
Set scaling to convert and display input values as any values.
Separate settings are made for inputs A and B.
One Point
When bank selection has been enabled, the prescale values for each
bank must be set in the prescale level. When bank selection has been
disabled, the prescale values must be set in the initial setting level.
Refer to "5.30 Using Prescale/Comparative Set Value Banks" (P.5-75).
Setting Parameter for Input A
Note: Not displayed on the K3HB-C or the K3HB-P.
The decimal point position for scaling values depends on the decimal
point position [
dp
] setting.
Initial setting level
R P C
Parameter Set value Meaning of set value
Input A
Prescale value X
(mantissa)
ps. ax
= 0. 0000
to
9. 9999
Input A prescale value
mantissa
Input A
Prescale value Y
(exponent)
ps. ay
-9
to
9
Input A prescale value
exponent
Input B
Prescale value X
(mantissa)
ps. bx
= 0. 0000
to
9. 9999
Input B prescale value
mantissa
See note.
Input B
Prescale value Y
(exponent)
ps. by
-9
to
9
Input B prescale value
exponent
See note.
Parameter Set value Meaning of set value
Decimal point position
dp
,,,,,
No decimal point
,,,,.,
One digit below the decimal
point is displayed.
,,,.,,
Two digits below the decimal
point are displayed.
,,.,,,
Three digits below the
decimal point are displayed.
,.,,,,
Four digits below the decimal
point are displayed.
ps. ax
L
0
(PS.AX)
dp
L
0
(DP)
ps. by
L
0
(PS.BY)
ps. bx
L
0
(PS.BX)
ps. ay
L
0
(PS.AY)