6 - 57
6 I/O Interface
Vision System FZ5 series Hardware Setup Manual (Z423)
6
-5 Serial In
terfac
e
6
6-
5-1
A
ll Series
6-5
Serial Interface
Serial interface of Sensor Controller differs by series.
Refer to the correct information for the series you are using.
Precautions for Safe Use
• Use only the cables designed specifically for the product. Use of other products may result in
malfunction or damage of the product.
• Always turn OFF the Sensor Controller's power before connecting or disconnecting a camera
or cable. Connecting the cable with power supplied may result in damage of the camera or
peripheral devices.
• For the cable that is flexed repeatedly, use the robotic cable type (Bend resistant camera
cable) to prevent damages.
• Do not apply torsion stress to the cable. It may damage the cable.
• Secure the minimum bending radius of the cable. Otherwise the cable may be damaged.
Precautions for Correct Use
• Check the following items on the communications cables that are used in the network.
• Are there any breaks?
• Are there any shorts?
• Are there any connector problems?
• When you connect the cable to the communications connectors on devices, firmly insert the
communications cable connector until it locks in place.
• Do not lay the communications cables together with high-voltage lines.
• Do not lay the communications cable near devices that generate noise.
• Do not lay the communications cables in locations subject to high temperatures or high
humidity.
• Do not lay the communications cables in locations subject to excessive dirt and dust or to oil
mist or other contaminants.
• Use a shielded twisted-pair communication cable.
• Maximum cable length is 15 m.
• Align the connector with the socket and press it straight into place, then secure it with the screws on
both sides of the connector.
6-5-1
All Series
Cable
How to Connect
