Omron FZ4 Series, User Manual, Page: 636 / 656

8
Appendixes
634 Operation log format FZ4 User's Manual
Return value
Returns the specified image logging information.
Getting an I/O module identifier name
GetIoModuleIdent
Parameters
ioModuleNo
I/O module number
0: Registers ParallelIo (Parallel I/O). (Fixed)
1: Registers any of the following I/O modules in the module communication system.
- SerialNormal: Serial non-procedure communication
- SerialNormal2: Serial non-procedure communication (FXXX series method)
- SerialPlcLink: Serial PLC link (Omron PLC)
- SerialPlcLinkM: Serial PLC link (Mitsubishi PLC)
2: Registers any of the following I/O modules for Ethernet communication system
- TcpNormal: TCP non-procedure communication
- UdpNormal: UDP non-procedure communication
- UdpNormal2: UDP non-procedure communication (FXXX series method)
- UdpPlcLink - UDP PLC link (Omron PLC)
- UdpPlcLinkM: UDP PLC link (Mitsubishi PLC)
3: Registers one of the following I/O modules or no registration.
- EtherCAT0: EtherCAT communication
- EtherNetIP: EtherNet/IP communication
Return value
If the I/O module identifier name is acquired successfully (character string), returns 0.
Otherwise, returns value other than 0.
Executing individual input of parallel I/O and other terminal states
GetPort
Parameters
ioIdent
Acquisition destination type
- ParallelIo: Parallel I/O
- Serial normal: Serial non-protocol communication
- UdpNormal: Ethernet UDP non-protocol communication
portNo
Port number to acquire
* Parallel I/O
DI0 to DI7: 0 to 7
DSA0: 100
STEP0 to 101
DSA1: 102
STEP1: 103
Return value
Returns the state of the specified terminal.
Acesst 1.0 6251194