7
M
eth
od
s
fo
rC
on
ne
ctin
g
an
d
C
om
m
un
ica
tin
g
w
ith
E
xte
rn
al
D
ev
ice
s
FZ4 User's Manual
Controlling/Outputting through Serial Communication (Non-procedure)
489
MEASUREUNIT or MTU
Performs a test measurement on the specified unit.
<Command format>
or
(Response format)
When processing is performed normally
When processing is not performed normally
(Parameters explanation)
Unit No.
Specifies the unit number to run a test with: 0 to the uppermost unit model number in the unit.
(Example)
The following sample command runs a test on unit number 5:
<Command>
<Response>
MOVSCENE or MSD
Copies the data for the scene with the number specified with command argument 1 to the scene with the
number specified with command argument 2. Deletes scene data with a number specified by command
argument 1 after completing copying. If there is already data at the copy destination, the copied data is
written over that data.
<Command format>
Acesst 1.0 6251194
Summary of Contents for FZ4 Series
