7
M
eth
od
s
fo
rC
on
ne
ctin
g
an
d
C
om
m
un
ica
tin
g
w
ith
E
xte
rn
al
D
ev
ice
s
FZ4 User's Manual
Controlling/Outputting through Serial Communication (Non-procedure)
439
[Note 2]: This is only displayed if the communication module is set to "non-procedure (TCP
Client)".
[Note 3]: Only when the communication module is set to "Non-procedure (TCP)" or
"non-procedure (TCP Client)", the initial setting value becomes [9876].
Reference:
Setting the Start-up Status [Startup Setting] (p.347)
3.
Tap [OK].
The settings are confirmed and the Ethernet window closes.
Setting Communication Specifications (RS-232C/422 - Non-procedure)
Communication specifications such as communication speed and IP addresses are set for serial
interface (RS-232C/422 connection) communication.
Reference:
Setting Communication Specifications (Ethernet - Non-procedure) (p.435)
Important
●
Before setting the communication specifications, set the "Serial (RS-232C/422)" communication module to
"Normal" or "Normal (Fxxx method)", save the setting to the controller, and then restart the system.
Reference:
Setting the Start-up Status [Startup Setting] (p.347)
●
Use the same communication specification settings for the controller and the external device.
●
If the operation mode (FZ4-11
/H11
only) is set to [Multi-line random-trigger mode], this setting is not
supported for line 1.
●
RS-422 is disabled on the FZ4-L35
series.
Reference
●
During setting of communication specifications, input signals cannot be handled. However, the input status can
be checked with [confirmation].
Reference:
Checking Communication Status (Non-procedure) (p.441)
●
When data is output via serial communication, output is suspended while communication specifications are
being set.
1.
On the Main screen, tap the [System] menu - [Communication] - [RS-232C/422:Normal].
The Serial window is displayed.
Acesst 1.0 6251194
Summary of Contents for FZ4 Series
