Omron FQ2-S/CH Series, User Manual, Page: 286 / 590

Inspecting with the Edge Width Inspection Item
284
FQ2-S/CH User’s Manual
Step 3 Adjusting the Judgement Parameters
[Inspect]
− [Inspection]
− [Add item.] − [Edge Width] − [Settings] Tab Page
1
Press [Judgement].
2
Set the D. Width range for an OK judgement.
Continuous measurements will be performed for the im-
ages that are displayed. The measured value is dis-
played beside the parameter name.
3
Press [OK] to enter the value.
Parameter Setting Description
Edge width
(edge in width)
When the result type is set to absolute value
Range: 0.0000 to 99,999.999
Defaults: Upper: 99,999.999
Lower: 0.0000
When the result type is set to relative values:
Range:
−
99,999.9999 or 99,999.999
Defaults: Upper: 99,999.9999
Lower:
− 99,999.9999
When the result type is set to ratios:
Range: 0.000 to 999.9999(%)
Defaults: Upper: 999.9999
Lower: 0.000
Set the upper and lower limits of the refer-
ence width for an OK judgment.
• You can change the output form for each measurement value to one of the following settings.
Press [ ] − [Result type] on the right of the display.
Absolute value (Default): The measured edge width is output.
Relative value: The difference from the reference value is output.
Ratio: The percentage of the reference value is output.
Blue for OK. Red for NG.
Upper limit
Lower limit
You can change the parameters for judgement conditions on the
Display Settings Display. Press
[ ] −
[Display setting] on the right
of the display to switch to the Display Settings Display.
Note
Note