Omron FH-2 Series, Hardware Setup Manual, Page: 72 / 244

Component Names and Functions
(F)
(G)
(H)
(D)
(E)
(I)
(A)
(C)
(B)
Connector name Description
(A) SD memory card
installation con-
nector Install the SD memory card. Do not plug or unplug the SD memory card during
measurement operation. Otherwise measurement time may be affected or data
may be destroyed.
(B) USB2.0 connector Connects to USB 2.0. Do not plug or unplug it during measurement. Otherwise
measurement time may be affected or data may be destroyed.
(C) USB3.0 connector Connects to USB 3.0. Do not plug or unplug it during measurement. Otherwise
measurement time may be affected or data may be destroyed.USB 3.0 has a
high ability to supply the bus power. Use the Sensor Controller by combining
USB 3.0, faster transport can be realized.
(D) Ethernet connec-
tor Connect an Ethernet device.Ethernet port, EtherNet/IP port, and PROFINET port
are sharing use.
(E) RS-232C connec-
tor Connect an external device such as a PLC.
(F) Monitor connector Connect a monitor.
(G) I/O (Parallel) con-
nector (control
lines, data lines) Connect the controller to external devices such as a sync sensor and PLC.
(H) Camera connec-
tor Connect cameras.
(I) Power supply ter-
minal connector Connect a DC power supply. Wire the FH Sensor Controller independently on
other devices.
Wire the ground line. Be sure to ground the FH Sensor Controller alone.
Use an attachment power terminal (male) for installation. For details, refer to
5-3 Sensor Controller Installation on page 5-5.
3 Configuration
3-14
FH Series Vision System Hardware Setup Manual (Z366-E1)