Omron F3SG-RA, User Manual

Page: 230 / 268

206
Ch
apt
e
r
5
Wir
ing
Ex
amples
(F3
S
G-
RA
Series
)
F3SG-R
User’s Manual
Input/Output Circuit and Applications
5-2-4. Muting using NPN Outputs
5-2-4-1. Standard Muting Mode/Exit-Only Muting Mode using NPN Outputs
The following is the example of External Device Monitoring enabled, Auto Reset mode, NPN output
and External Test in 0 V Active.
[DIP Switch settings] *3
 : Indicates a switch position.
Configure functions with the DIP Switches before wiring.
[Wiring Example]
Function DIP-SW1 DIP-SW2
Receiver
EDM Enabled
Auto Reset (factory default setting)
NPN
Emitter External Test: 0 V Active
㻞 㻻㻺 㻞 㻻㻺
㻟 㻻㻺 㻟 㻻㻺
㻠 㻻㻺 㻠 㻻㻺
㻣 㻻㻺 㻣 㻻㻺
㻠 㻻㻺
OSSD1 : Black OSSD2 : White 24 VDC : Brown Not used : Yellow TEST : Black Not used : White 24 VDC : Brown 0 VDC : Blue
Receiver
Emitter
0 VDC : Blue AUX : Red MUTE B : Pink MUTE A : Gray RESET : Yellow *1
S1: Test Switch (Connect the line to 24 V if this switch is not required)
S2: Override Cancel Switch
S3: Lockout/Interlock Reset Switch or Override Switch
S4, S5: Muting sensor
KM1, KM2: Safety relay with forcibly guided
contacts (G7SA) or magnetic contactor
M: 3-phase motor
S1
S3
F39-JG A-L F39-JG A-D
Power Supply
+24 VDC
0 VDC
S5 S2
*2
S4
KM1 KM2
KM1
KM2
KM1
KM2
M
Unblocked
Blocked
MUTE A
MUTE B
OSSD
Test Switch (S1)
Beam state
PLC *4
IN
*1. Also used as Override input line.
*2. Make sure to connect an override cancel switch to the Reset line
when using the override function. Otherwise the override state may
not be released by the override cancel switch, resulting in serious
injury.
*3. The functions are configurable with DIP Switch. Refer to Chapter 3
Setting with DIP Switch for more information on setting the
functions by the DIP Switch.
*4. When connecting to the PLC, the output mode must be changed
with the Configuration Tool according to your application.