Omron F3SG-PG Series, User Manual, Page: 197 / 473

167
F3SG-SR/PG
User’s Manual
Ch
apt
e
r
3
Tea
c
h-
in
(F
ix Bla
n
king / Flo
a
ting
Blank
in
g
)
Setting with Intelligent Tap
E
3-7. Teach-in (Fix Blanking / Floating Blanking)
Make sure the Responsible Person test the operation of the F3SG-SR after setting with the
Teach-in to verify that the F3SG-SR operates as intended. Unintended settings may cause a
person to go undetected, resulting in serious injury.
3-7-1. Setting Fixed Blanking by Teach-in

Overview
You can teach-in the settings of the Fixed Blanking by interrupting the target area of the Fixed
Blanking. The Teach-in described in this chapter is performed with the Intelligent Tap connected to the
F3SG-SR and using the Push Switch or the Muting Input A.

Teach-in steps
Perform the Teach-in of the Fixed Blanking based on the following steps.
(1) Connect Intelligent Tap to F3SG-SR
(2) Beam Alignment
(3) DIP Switch Setting
(4) Transition to Teach-in Mode
(5) Teach-In and Check Processes
(6) Restart
(1) Connect Intelligent Tap to F3SG-SR
Connect the Intelligent Tap to the F3SG-SR.
(2) Beam Alignment
Perform the beam alignment for the F3SG-SR . In the case of the Optical Synchronization, install the
F3SG-SR so that the synchronization beams are clear. For detailed beam adjustment steps, see
5-3-4-
5. Mounting IP69K Model .
Misalignment during the Teach-in may result in an unintended setting or a failure of the Teach-in.
F3SG-SRA

F3SG-PGA-A F3SG-PGA-C
F3SG-SRB

F3SG-PGA-L