Omron F160 Vision Sensor, Operation Manual, Page: 52 / 148

43
Understanding Setting Operations
Section 2-3
2-3-6 STEP 6: Entering Run Mode and Starting Inspections
This section describes how to enter Run Mode and start inspections. The
measurement results will also be output to the parallel interface.
2-3-6-1 Entering Run Mode
1. Move the cursor to OK to change the mode.
2. Press the ENT Key.
The mode selections will be displayed.
3. Use the Up/Down Keys to move the cursor and select RUN.
The Run Mode Screen will be displayed.
Start
inspections.
Help
Display
settings
ESC
SHIFT +
ENT SHIFT +
SHIFT +
2
Enter
Run Mode.
1
Adjust judgement
precision
By region,
position compensation
Adjust
measurement time.
Judgement
Measurement time
Use the help function if
the inspection is not correct.
The type of screen display
(freeze or through) can be changed.
Refer to page 37.
Refer to page 42.
Refer to page 36.
Refer to page 37.
0.Scn 0 MON
63ms
OK
OK
OK OK
OK OK
OK
0.Scn 0 MON
63ms
OK
OK
OK OK
OK OK
SET
MON
RUN
SYS
TOOL
SAVE
RUN
OK