![background image](http://html1.mh-extra.com/html/omron/f160-vision-sensor/f160-vision-sensor_operation-manual_741258032.webp)
23
Understanding Setting Operations
Section 2-3
2-3-2-2
When Console Is Selected
1.
Set the workpiece in the correct position.
2.
Press the ENT Key on the Console.
A confirmation message will be displayed.
3.
Select Yes if that image is acceptable as the reference image.
The reference image has now been registered.
2-3-2-3
When STEP Is Selected
1.
Set the workpiece and input a sync signal for the STEP signal.
2.
When the signal has been input, select End.
Note Up to 36 images can be registered one after the other.
An image selection message will be displayed.
3.
Use the Up and Down Keys to switch between images and select one im-
age to be used as the reference for inspection.
4.
Once the image has been decided upon, press the ENT Key to select it.
ENT:Save this image ESC:Back
Save image to use for settings.
This image will be
the reference image.
Redo
Yes
step
3
Stored images: 5/36
Back
End
↑
↓
:Switch ENT:Select ESC:Back
Image to use: 0 [0 to 35]
step
3
0
Summary of Contents for F160 Vision Sensor
