Omron F160 Vision Sensor, Operation Manual, Page: 31 / 148

22
Understanding Setting Operations
Section 2-3
2-3-2 STEP 2: Registering Reference Images
Copy Sample A found at the end of this manual. Register the Sample A image
on the F160. This image will be used as a reference image for setting inspec-
tion conditions.
CHECK
Registered reference images are lost when the power is turned OFF or the
image save function is used. For possible future amendments to inspection
conditions, it is recommended that the reference images are backed up to a
computer or Memory Card. Up to 36 reference images can be registered when
a Console is being used. When a reference image is not backed up, the work-
piece must be displayed in the same position and size as the previous inspec-
tion to recreate the reference image. (Refer to page 78.)
2-3-2-1 Selecting Image Registration Methods
The Console or the parallel interface STEP signal can be used to register
images.
HELP
Console
Once the image is confirmed on the screen, Console Keys are pressed to reg-
ister the image.
HELP
STEP Signal
A sync signal is input to the STEP signal in the parallel interface to register
images. Up to 36 images can be registered, i.e., you can register several
workpieces as they travel down the production line and select one appropriate
image as the reference image.
Select one
reference image
Changes the camera
shutter speed.
Changes the brightness
of Intelligent Lighting.
ESC SHIFT +
ENT SHIFT
+
2
Select image
registration methods.
1
Take image and
check it.
Record up to 36 images
on STEP signal.
Console
STEP signal
Refer to page 24.
Refer to page 25.
3
Intelligent Lighting can be
adjusted when Intelligent Lighting
has been specified in the system
camera settings.
STEP 3
0.Scn 0 =SET= Ref image
One image must be
saved as a reference
for inspection.
S+
←→
:Display S+ENT:Shutter
S+ESC:Adjust illumination
Start
>>Ref image
Region
Position
End
Set the method to
use to store images.
Console STEP Back