Omron Enterprise Manager 2100, User Manual

Page: 49 / 96

Chapter 5: Configuration
Figure 5-1. Hover Over the SetNetGo Selection Box
Hover over the selection box to reveal its boundaries. (See the cursor in the preceding fig-
ure.)
NOTE: It is not necessary to enable (check) the checkbox within the
SetNetGo selection box. The checkbox determines whether SetNetGo starts
automatically when you open MobilePlanner.
Figure 5-2. SetNetGo Interface—Status Tab, Home Screen
This screen provides an overview of link status, IP addresses, and installed software versions.
5.4 Configure Management Interface Network Settings
To configure the Management Network, you require:
l
A dedicated static IP address. (Do not use 1.2.3.4. That address is permanently assigned
to the Maintenance Ethernet port.)
l
The subnet mask for the Management network.
l
The IP address of the network Gateway.
14413-200 Rev. A Enterprise Manager 2100 User’s Guide 49