Omron Enterprise Manager 2100, User Manual

Page: 48 / 96

48 Enterprise Manager 2100 User’s Guide 14413-200 Rev. A
5.3 Connect Your PC to SetNetGo on the Enterprise Manager 2100
Connect your browser to SetNetGo and configure SetNetGo access as follows:
1. Open a browser and type: HTTP://1. 2. 3. 4 and then press enter.
2. If a certificate warning dialog opens, ignore it and close the dialog.
3. In the SetNetGo web interface, click the Security Tab and then click SetNetGo Access
and check Enabled next to the following:
l
Management and Fleet Interface.
l
(Optional) Remote reboot.
4. Change the account password (default is no password) as required and click Apply .
Enable Fleet Account Access
If you want to strictly control access to the Fleet through MobilePlanner you can enable account
access and create authorized user accounts with passwords.
If you enable access control, you must also enable at least the Admin account. You can also:
l
Enable default Operator and Viewer accounts.
l
Create additional user accounts.
l
Modify account permissions to control access privileges.
To enable fleet account access
1. In the SetNetGo web interface, click the Security Tab and then click Fleet Accounts and
2. Check
Enabled next to Access Control and press Apply .
3. Wait for the change to take effect and refresh your browser if necessary. (You might see
a warning that you enabled access control without creating accounts.)
4. Check Enabled next to the admin Username .
5. Enter and confirm a new password, and then click
Apply .
6. Optionally, repeat Step 4 and Step 5 for the default operator and viewer accounts,
which have different access privileges compared to the admin account.
7. Optionally add a new named user account and repeat Step 4 and Step 5. If you create
a new user account you might also want to click the Modify Permissions link to fur-
ther control user access.
Access SetNetGo from Mobile Planner
During normal operation, you access SetNetGo through the MobilePlanner software as follows:
1. Start the MobilePlanner software on your PC.
2. Click anywhere in the SetNetGo selection box, to access the SetNetGo interface.