Omron E3X-CIF11, Operation Manual

Page: 71 / 138

60
Wiring the CompoBus/S Communication Unit Section 3-4
3-4 Wiring the CompoBus/S Communication Unit
3-4-1 Wiring
Note The CompoBus/S communications power supply provides power to the Com-
munication Unit and all the Sensors connected to it. Select a power supply for
the Communication Unit so that it has sufficient capacity for the current con-
sumption of the Sensors.
The Unit can be supplied power from the CompoBus/S Network. Power is
supplied from a special Flat Cable. Be sure to confirm that the power supply
capacity of the Flat Cable is not exceeded.
The following crimp terminals are recommended (from Weidmuller).
The following tool is recommended.
Manufacturer: Weidmuller
PZ1.5 Crimper (Part No. 900599)
Contact: Weidmuller Inc., Nihon Weidmuller Co.Ltd., phone: 03-5820-5748
The tightening torque is 0.2 to 0.4 N·m
.
BD H
BD L
NC NC BS
−
BDL BDH
BS+
CompoBus/S
communications
power supply
CompoBus/S communications
Sleeve (part No.: 046290) Two-wire insertion type (part No.: 901851)