Omron E3X-CIF11, Operation Manual

Page: 51 / 138

40
Explicit Message Communications Section 2-6
Write Number of Sensors Writes to the Fiber Amplifier Sensor Communication Unit’s internal memory
the number of Sensors that are connected. An error will occur if this command
is executed when pin 3 is OFF. The data is given as a 2-byte (4-digit) hexadec-
imal value between 0001 Hex and 0010 Hex. The default setting is 16 Sen-
sors.
Write Number of Light
Level Monitor Units Writes to the Fiber Amplifier Sensor Communication Unit’s internal memory
the number of Units to be monitored for incident light levels when using two-
word mode with incident light level monitoring (DIP switch pin 1 OFF and 2
ON). When pin 3 is ON, the value that was written for the number of Units to
be monitored for incident light levels is enabled. The data is given as a 2-byte
(4-digit) hexadecimal value between 0000 Hex and 0010 Hex. The default set-
ting is 16 Units.
2-6-4 Operation Commands
Executes teaching and other operations for the Sensors connected to the
Communication Unit. When an OMRON master is used, the formats of the
command and response blocks are as follows:
Command Block
Response Block Normal Format
Error Format
10 Always 0.
11 Always 0.
12 Always 0.
13 Always 0.
14 Always 0.
15 Always 0.
Bit Contents
Destination
node
address
Service
Code
Class ID
Instance ID
Operation
data
009C (fixed)
1 byte 1 byte
2 bytes
2 bytes
1 byte
Number of
received bytes
Destination
node
address
Service
Code
0002
2 bytes 1 byte
90 (fixed)
1 byte
Number of received
bytes
0004
2 bytes 1 byte 1 byte 2 bytes
94 (fixed)
Destination
node
address
Service
Code
Error Code