Omron E3X-CIF11, Operation Manual

Page: 19 / 138

8
Connecting Fiber Amplifier Units Section 1-3
1-3-3 Supported Fiber Amplifier Units
The Communication Unit can be connected to the following Fiber Amplifier
Units.
Note 1. The incident light level can be monitored when Unit is turned ON or OFF.
2. Prewired Units (E3X-DA11/21/41/51-N, E3X-DAB11-N, etc.) and Water-
resistant Units (such as E3X-DA14V) cannot be used. Connecting these
Units will disable the power reset switch.
3. Connections of E3X-DA6/8, E3X-DAB6/8, E3X-DAG6/8, E3X-DA6TW, and
E3X-DA8TW are restricted depending on the lot number. Refer to page 6
for details on restrictions.
4. Install the E39-TM1 Terminal Block Unit as far away from the Communica-
tion Unit as possible.
1-3-4 Slave Connectors for Fiber Amplifier Units
Fiber Amplifier Units must be used with Slave Connectors (purchased sepa-
rately). When connecting a Fiber Amplifier Sensor Communication Unit, how-
ever, the Slave Connector that can be connected to the Fiber Amplifier Unit is
restricted according to the Communication Unit used, as shown in the follow-
ing table.
(Yes: Can be used; No: Cannot be used)
Note Do not use a E3X-CN11 or E3X-CN21 Master Connector with a Fiber Ampli-
fier Unit.
Model
number
Unit type Output
type
Monitor
output
Number of
thresholds
Number of
allocated
unit numbers
E3X-DA6 Standard model NPN None 1 1
E3X-DA8 PNP
E3X-DA6-P ON/OFF inci-
dent light level-
monitoring
model
(See note 1.) NPN
E3X-DA6TW Twin-output
model
NPN 2 2
E3X-DA8TW PNP
E3X-DAB6 Mark-detecting
model
(blue LED) NPN 1 1
E3X-DAB8 PNP
E3X-DAG6 Mark-detecting
models
(green LED) NPN
E3X-DAG8 PNP
E39-TM1 Terminal Block
Unit NPN/PNP --- ---
Fiber Amplifier Sensor
Communication Unit
Slave Connector for Fiber Amplifier Unit
Cordless With 1-wire cord With 2-wire cord
E3X-CN02 E3X-CN12 E3X-CN22
E3X-DRT21 (DeviceNet) Yes No No
E3X-SRT21 (CompoBus/S) Yes No No
E3X-CIF11 (RS-422) Yes Yes No