7 - 7
7 Troubleshooting and Maintenance
E3NW-CCL CC-Link Digital Sensor Communications Unit User’s Manual (E431)
7-2
Device Mai
n
ten
ance
7
7-2
-1 Cleaning Methods
7-2
Device Maintenance
This section describes cleaning methods, inspection methods, and the E3NW-CCL replacement
procedure for regular device maintenance.
Clean the Communications Unit regularly to keep it in optimum operating condition.
•
For daily cleaning, use a soft, dry cloth.
•
If dry wiping does not remove all of the dirt, use a diluted mild detergent (2%) and wring out the cloth
thoroughly before wiping.
•
Leaving rubber items, plastic items, or tape on the Unit for an extended period of time may leave
stains. Remove any such items from the Unit when cleaning.
Precautions for Correct Use
Never use benzine, paint thinner, or any other volatile cleaning solutions or chemical wash cloths
for cleaning. These products can damage the coating on the Unit.
Perform regular inspections to keep the Communications Units in optimal working condition.
Inspections are best performed once every 6 months to 1 year.
However, in extremely humid environments, high-temperature environments, dusty environments, or
other extreme environments, more frequent inspections are recommended.
Prepare the following materials before performing an inspection.
Daily Required Items
•
Phillips screwdriver and flat-blade screwdriver
•
Screwdrivers for communications connectors
•
Voltage tester (or digital voltmeter)
•
Industrial alcohol and 100% cotton cloth
Possibly Required Items
•
Synchroscope
•
Pen-writing oscillograph
•
Thermometer and hygrometer
7-2-1
Cleaning Methods
7-2-2
Inspection Methods
Materials Required for Inspection
Summary of Contents for E3NW-CCL
Page 1: ...E3NW CCL CC Link Digital Sensor Communications Unit User s Manual Cat No E431 E1 08 ...
Page 114: ...A Appendices A 34 E3NW CCL CC Link Digital Sensor Communications Unit User s Manual E431 ...
Page 116: ...B B 2 E3NW CCL CC Link Digital Sensor Communications Unit User s Manual E431 ...
Page 117: ......
