4.
Converting the program for CS
On the CX-Programmer, convert the program for CS.
(1) Start the CX-Programmer, and open the program file for CV/CVM1. (Select
File – Open.
)
(2) Change the Device Type from CV/CVM1 to CS1 (Select
PLC - Change Model
to show the below dialog box.)
* Keep the data loaded from CV/CVM1 when you change the model to convert the program. The only data that
can be converted is ladder program. The others will be cleared to default state.
(3) The instructions are converted. The Output Window shows the conversion results. Double-click an error
shown on the Output Window to jump to the corresponding section of the ladder program.
Errors and warnings at conversion will be displayed.
Double-click an error or a warning to jump to the
corresponding rung section.
Some instructions can not be converted. In that case, modify the ladder program according to the procedures
in
Appendix A. Instruction conversion by the Change Model function of CX-Programmer.
You can check the
program by selecting
Program - Compile
from the menu. The Output Window shows the checking results. Be
sure to execute the Program Check because there are some instructions to which an error is not displayed
when the model is changed.
8
Summary of Contents for CV/CVM1
Page 1: ...Replacement Guide CV CVM1 From CV CVM1 to CS1 ...
Page 10: ...MEMO ...
Page 32: ...P076 E1 01 2011 0911 ...
