4-9
4 Programming Device
CP1E CPU Unit Hardware User’s Manual(W479)
4-
2 Co
nnec
ting
by U
S
B
4
4-
2-2 Installing the
USB Drive
r
The following restrictions apply to the connection of the CP1E to a computer due to the USB specifica-
tions. Keep these restrictions in mind when using the USB port.
•
Only one CP1E CPU Unit can be connected by USB to a single personal computer. It is not possible
to connect multiple CP1E CPU Units simultaneously.
•
Do not remove the USB cable while connected online. The application must be offline before the
cable is removed. The CX-Programmer will not go online simply by reinserting the USB cable. Place
the CX-Programmer offline before reinserting the USB cable, then place it online again.
•
If the cycle time is too long, it may result the communication failure when CX-Programmer tries to
work online. In this case, click
the Settings
button on the right side of Network Type in the
Change
PLC
dialog box and increase the value in
Response Timeout(s)
.
The USB driver for CP1E must be installed on the computer running the CX-Programmer in order to
connect the CP1E to the computer via USB.
When the personal computer is connected to the CP1E by USB cable, the personal computer automat-
ically recognizes the device and the USB driver installation is started.
Connect the computer’s USB port (1) and the CP1E CPU Unit’s peripheral USB port (3) with a USB
cable (2).
Restrictions on Connecting by USB
4-2-2
Installing the USB Driver
Windows 2000 or Vista
(1)
(2)
(3)
Summary of Contents for CP1E-E**D Series
