Omron CJ1W-FLN22, Operation Manual, Page: 61 / 277

35
Network Installation Section 3-6
3-6-2 Recommended Products
The following products are recommended for use with the CS1W-ETN21
Ethernet Unit.
3-6-3 Precautions
Precautions on Laying Twisted-pair Cable
Basic Precautions • Press the cable connector in firmly until it locks into place at both the hub
and the Ethernet Unit.
• After laying the twisted-pair cable, check the connection with a 10Base-T
cable tester.
Environment Precautions • The UTP cable is not shielded, and the hub is designed for use in OA
environments. In environments subject to noise, construct a system with
shielded twisted-pair (STP) cable and hubs suitable for an FA environ-
ment.
• Do not lay the twisted-pair cable together with high-voltage lines.
• Do not lay the twisted-pair cable near devices that generate noise.
• Do not lay the twisted-pair cable in locations subject to high temperatures
or high humidity.
• Do not lay the twisted-pair cable in locations subject to excessive dirt and
dust or to oil mist or other contaminants.
Part Maker Model
number
Specifications Inquires
Hub 10Base-T
Allied
Telesis RH509E 9-port hub Allied Telesis
(0120) 86-0442
(in Japan only) MR820TLX 9-port hub with 10Base-5
backbone port
Twisted-pair
cable 100Base-TX
Fujikura F-LINK-E
0.5mm x 4P STP (shielded twisted-
pair) cable: Category 5,
5e
Note: Impedance is lim-
ited to 100
Ω
.
---
Fujikura CTP-LAN5
0.5mm x 4P UTP (unshielded twisted-
pair) cable: Category 5,
5e
10Base-T
Fujikura F-LINK-E
0.5mm x 4P STP (shielded twisted-
pair) cable: Category 3,
4, 5, 5e
Note: Impedance is lim-
ited to 100
Ω
.
Fujikura CTP-LAN5
0.5mm x 4P UTP (unshielded twisted-
pair) cable: Category 3,
4, 5, 5e
Connectors
(Modular
plug) STP Plug
Panduit
Corp MPS588 ---
UTP Plug
Panduit
Corp MP588-C ---