Omron A2W-R**-WC1 Series, User Manual

Page: 65 / 96

5 - 3
5 Registration in the ID Mode
Wireless Pushbutton Switch User’s Manual (A265)
5
-1 Ho
w t
o
R
egist
er S
lave Bu
tto
ns t
o
Mast
er Unit
5
5-
1-1 S
tep
s to Register the
S
lave Buttons
Register the Slave button one by one.
Register operation is performed on both Master Unit and Slave buttons.
If you want to register multiple Slave buttons to the same output number of one Master Unit, repeat the
operation for a Slave button one by one as shown below.
 Operation Procedure Flowchart
5-1-1 Steps to Register the Slave Buttons
Start registration
Registration failure
Lit green
Flashing
green
<Master Unit> <Slave buttons>
* Retry the operation.
* Check whether the number of Slave buttons registration
to the Master Unit is over the upper limit of 8 Units.
1. Set the mode
settings switch
to "ID".
2. Set the output
settings switch
to "1", for
example.
3. The output
LED (example:
OUTPUT 1)
lights in
yellow.
4. Press the
pushbutton
three times.
5. RCV LED
arrives.
6. Completion of
registration