13
Mounting a Board
Section 2-1
Note
In the factory setting, the Board ID is set to 0.
2-1-3
Mounting the Board on the PC
After setting the ID, mount the CompoNet Master Board on the PCI slot of the
PC.
Precautions for Correct Use
•
Be sure to turn off the PC and all peripheral devices, when you mount or
remove a CompoNet Master Board.
•
Take necessary measures to prevent static electricity before you start the
procedures to mount a CompoNet Master Board. Otherwise, the electricity
may break the Board or the PC.
•
Be sure not to damage any memories or other components in the PC, when
you work on mounting or removing a CompoNet Master Board.
•
Do not touch any surface or components of the CompoNet Master Board by
hand.
Note
The procedure to mount a Board for PCI bus differs by PCs. Refer to the
Operation Manual of the PC you use in order to follow the correct procedures.
Follow the mounting procedure given below:
1.
Disconnect all cables from the CompoNet Master Board. This includes the
communications cables and power supply cables.
2.
Turn off the PC to which a Board is mounted. Disconnect the electrical
cord.
3.
Remove the package of the PC as instructed in the Operation Manual, and
prepare it to mount or remove a CompoNet Master Board.
4.
Place the PCI bus connecter on the PC and the connector on the
CompoNet Master Board in the correct positions and orientations. Push
the CompoNet Master Board to the end. Be sure the connector on the
CompoNet Master Board is pushed evenly onto the connector on the PC.
5.
Do not apply an excessive load to the Board while mounting it.
6.
Pull the CompoNet Master Board lightly to confirm that it won't come out.
7.
Tighten the screws on the left side of the CompoNet Master Board panel
with 0.5 N
⋅
m torque, and secure the Board.
Summary of Contents for 3G8F7-CRM21
