Omron 3G8F7-CRM21, User Manual

Page: 210 / 238

190
Preparing and Mounting Flat Connectors on the Cables
Section E-4
E-4-3 Preparing Connectors for Flat Cables II
Preparing and
Mounting the DCN5-
TR4 Flat Connector
Sockets
Names of Flat Connector Socket components
1. Cutting the Cable (required only when the cable is extended or when a
Terminating Resistor is connected)
At the tip of the cable, cut the cable perpendicular to the cable length.
To prevent short-circuiting, use a sharp cutting tool such as a nipper. After
cutting, confirm that there is no remaining wire coming out.
2. Setting the Cable Stopper (required only when the cable is extended or
when a Terminating Resistor is connected)
For extending cables or connecting a Terminating Resistor, the cable can end
within the Connector. Thus place a cable stopper in advance.
Put the cable in the cover. Position the cable so that the cable tip touches the
stopper.
Cover
Cable stopper