00026057.DOC, Version 1.0
16/26
DESCRIPTION
The equalizer is designed for professional application. The inputs and outputs are located on the rear panel,
the gain controls on the front panel.
Occupation balanced XLR connection:
2
1
3
1
2
3
Balanced use with XLR connectors
1 = Ground / Shield
2 = Hot (+)
3 = Cold (-)
For unbalanced use pin 1 and pin 3 have to be bridged
Input
Output
Occupation jack plug:
Unbalanced use of
mono 1/4" jack plugs
Tip =
Signal (+)
Sleeve =
Ground / Shield
Tip
Sleeve
Strain relief clamp
Balanced use of
Tip =
hot (+)
Sleeve =
Ground / Shield
Tip
Sleeve
Strain relief clamp
stereo 1/4" jack plugs
Ring =
cold (-)
Ring
For connection of balanced and
unbalanced plugs, ring and sleeve have
to be bridged at the stereo plug.
The occupation of the screw connectors is as follows:
Connection 1 =
Connection 2 = Signal -
Connection 3 = Shield
INSTALLATION
RACK MOUNTING
The equalizer is built for 19" racks/483mm. The minimum mounting depth is 185 mm. The height is 88 mm.
You can fix the equalizer with four screws M6 in the rack.
When mounting the equalizer into a rack, please make sure that there is a proper air circulation.
Please make sure that there is enough space around the device so that the heated air can be passed on.
The rack should be provided with a cooling fan.
Be careful when mounting the equalizer into the rack. Put the heaviest devices into the lower part of the rack.
Be aware that fastening the equalizer with four screws on the front panel is not enough. In order to ensure
safety, additional fastening by using ground and side bars is necessary.
If racks are to be transported or used for mobile use, additionally fasten the devices by connecting the rear
brackets with the side or ground bars of the rack. In this way, the equalizer cannot be pushed backwards.
The front panel alone is not designed to absorb acceleration forces occurring during transportation.
