OmniSwitch os6900, Network Configuration Manual, Page: 667 / 942

Configuring QoS Using Condition Groups in Policies
OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 25-59
In this case, remove the port group from the condition first; then enter the no policy port group
command. For example:
-> policy condition cond4 no source port group
-> no policy port group techpubs
The policy condition command removes the port group from the policy condition. (See “Creating Policy
Conditions” on page 25-45 for more information about configuring policy conditions.) The port group is
deleted at the next qos apply .
Verifying Condition Group Configuration
To display information about condition groups, use the following show commands:
See the OmniSwitch CLI Reference Guide for more information about the syntax and output for these
commands.
show policy network group Displays information about all pending and applied policy network
groups or a particular network group. Use the
applied keyword to dis-
play information about applied groups only.
show policy service Displays information about all pending and applied policy services or a
particular policy service configured on the switch. Use the
applied key-
word to display information about applied services only.
show policy service group Displays information about all pending and applied policy service
groups or a particular service group. Use the
applied keyword to display
information about applied groups only.
show policy mac group Displays information about all pending and applied MAC groups or a
particular policy MAC group configured on the switch. Use the
applied
keyword to display information about applied groups only.
show policy port group Displays information about all pending and applied policy port groups
or a particular port group. Use the
applied keyword to display informa-
tion about applied groups only.