OmniSwitch os6900, Network Configuration Manual, Page: 645 / 942

Configuring QoS QoS Defaults
OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 25-37
Policy Action Defaults
The following are defaults for the policy action command:
Note that in the current software release, the deny and drop options produce the same effect that is, the
traffic is silently dropped.
Note. There are no defaults for the policy condition command.
Default (Built-in) Policies
The switch includes some built-in policies, or default policies, for particular traffic types or situations
where traffic does not match any policies. In all cases, the switch accepts the traffic and places it into
default queues.
•
Other traffic —Any traffic that does not match a policy is accepted.
•
The switch network group —The switch has a default network group, called switch , that includes all IP
addresses configured for the switch itself. This default network group can be used in policies. See
“Creating Network Groups” on page 25-54 for more information about network groups.
How often to check for matching
flow messages log interval 60 seconds
Whether to count bytes or pack-
ets that match the rule. count packets
Whether to send a trap for the
rule. trap yes (trap sent only on port disable
action or UserPort shutdown oper-
ation)
Whether the rule is saved to the
default list default-list yes (all policy rules belong to the
default list unless otherwise speci-
fied at the time the rule is created)
Description Keyword Default
Whether the flow matching the
rule must be accepted or denied disposition accept
Tri-Color Marking (TCM) mode
- committed rate and burst size
- peak rate and burst size
cir cbs
pir pbs
Single-rate TCM (srTCM) mode
CIR=0, CBS=10K
PIR=0, PBS=10K
Description Keyword Default