Resistance of the internal “pull-up resistor” to positive voltage supply, Ohm
1500
Omnicomm LLS-AF 4
Preparation
Fuel Tank Preparation
1. Select the location for Omnicomm LLS sensor installation, taking into account the
following requirements:
The installation location should be as close to the geometric center as possible and be
placed at the deepest level of the tank:
When installed, the sensor should not be in contact with reinforcement ribs and existing
equipment inside the tank
Installing two sensors in one fuel tank allows to significantly reduce the de-pendence of
the fuel level on the vehicle inclination angle:
Preparation
Omnicomm LLS 30160, LLS-AF 4 Fuel Level Sensors
7
