TVM PRO Television Wall Mount
Installation Instructions
Models:
TVM 21 PRO
TVM 27 PRO
Parts List:
Item Description Quantity
1 Wall
Bracket
1
2 Support
Arm
1
3 Platform
1
4
Platform Swivel Bracket
1
5 Nose
Piece
1
6 Square
Washer
1
7 Platform
Slide
Bar
1
8 Medium
Hex
Wrench
1
9
5/16” x 1” Platform Screw
1
10 Flat
Washer
1
11 Small
Hex
Wrench
1
12
M6 x 20mm Tilt Screws
2
13
3/8” x ½” Pivot Bolts
2
14
5/16” Platform Lock Nut
1
15 Large
Hex
Wrench
1
16 Wall
Bracket
Cover
1
17 Wall
Anchors
4
18
¼” x 2” Lag Bolts
4
19 Security
Strap
1
Step 1
Use electronic stud finder to locate center of stud.
Note:
When mounting to masonry, go directly to Step 2
Step 2
Use wall bracket (1) as template to mark mounting hole locations.
Wooden Stud Mounting:
Using 1/8” drill bit, drill mounting holes to a depth of 2”.
Using a 10mm wrench, bolt the wall bracket to the wall with the supplied ¼” lag bolts (18).
Note:
To make installation easier, dab a bit of liquid soap onto the bolt threads before driving bolt into the stud.
Masonry Mounting:
Use a 3/8” masonry drill bit, and drill mounting holes to a depth of 2”.
Insert wall anchors (17) into mounting holes, and tap flush with hammer.
Using a 10mm wrench, bolt the wall bracket to the wall with the supplied ¼” lag bolts (18).
Step 3
3a)
Slide wall bracket cover (16) over support arm, with flat side facing wall.
Place flat washer (10) into round depression in center of platform swivel bracket (4).
Insert platform tilt screws (12) up through two countersunk holes in bottom of platform
swivel bracket.
3b)
Insert 5/16” platform screw (9) down through center of platform swivel bracket. Place
platform swivel bracket assembly onto top plate at end of support arm, with main bolt
passing through center hole.
Install square washer (6) onto platform main bolt, and then thread platform lock nut (14)
onto platform screw. Tighten platform screw with medium hex wrench (8). Do not over-
tighten or platform will not swivel.
