Page 22
www.ctmmixers.com
Omnex Controller Reset
Resetting a R160 receiver for a new T110 transmitter code.
Before starting this procedure, remove the R160 “board ” from the case. Release the clip
on either side with a flat blade screwdriver and pull down. Keep the receiver connected
to the truck power.
1. Power up the Receiver. The (E-Stop) light and the (Link) light will come on red
(provided the Transmitter is off), and the (Status) light will come on green.
2. Turn on the Transmitter by pressing and holding the red [E-Stop] button and the
green [Power] button, and then releasing first the red [E-Stop] button and then the
green [Power] button. This will power up the Transmitter into Download Mode. The
yellow (Active) light will begin flashing slowly (once per second).
3. Press and hold the [SETUP] button (yellow button on left side just above the left
connector) on the Receiver. The (Status) light (far right LED-Green ) will flash slowly.
Continue to hold the [SETUP] button (approximately 5 seconds) until the (Status) light
starts flashing rapidly and then release; it will now remain on steady. NOTE: If left idle
in Setup Mode for over 30 seconds, the Receiver will time out, indicated by the red
(Status) light flashing rapidly. To return to Setup Mode, repeat step 3.
4. Press and release the green [Power] button on the Transmitter to start sending the
ID Code to the Receiver. On the Transmitter, the red (Battery) light will come on and
the yellow (Active) light will flash rapidly; on the Receiver, the (Link) light will become
green. Once the ID Code has been downloaded, the red (Battery) light and the yellow
(Active) light on the Transmitter will go out. The (Link) light on the Receiver will
change from green to red.
( Picture on next page )
