Omicron CMC 310, User Manual

Page: 13 / 44

OMICRON 13
Test set overview
3.2.5 AUX DC (DC power for test objects)
The AUX DC output can be used to supply test objects with DC voltage. The output voltage
can be configured to 0 … 264 V in the control software or control device.
► Refer to the documentation of the control software for more information.
The AUX DC output is galvanically separated from all other connections of the CMC 310 .
The output is protected against short-circuit, overload, and overtemperature.
An LED in the upper left corner indicates if the output is active.
WARNING
Death or severe injury caused by dangerous voltage levels due to control by
software possible
The AUX DC output can be programmed to output dangerous voltage . This may lead to
damage to property or persons. Since the output is only controlled by software, a wrong
AUX DC setting (e.g. set in software, software or hardware error) could lead to an
unexpected value (up to 264 V).
► Make sure that the voltage applied at the AUX DC output of the CMC test set interface
is safe before connecting any test leads to this output.
► Follow the wiring procedure described in section "Wiring" in the Safe use of CMC test
sets manual.
LED status Description
Red Output is active
OFF Output is inactive