Current amplifier CMA 56
10
2.2
Important Instructions
Please take note of the following instructions for proper handling of the
CMA 56 current amplifier:
• Note the safety instructions!
• Operate the CMA 156 only with mains supplies with a
protective grounding!
• Operate the CMA 56 only with a CMC for DOS software version > 2.45.
• The CMA hardware and the CMC hardware should only be turned on or
off (by the switch on the front panel), if no test device is connected.
• When connecting and disconnecting the test object make sure that the
amplifier is not activated in the software (if the switch in the control
software is "On", another automatic sequence will run, a program
sequence or a transient output is active, or other signals are connected
to the input on the rear panel of the CMA 56 ("Ampl. in")).
• When the CMA 56 is used, make sure that an unobstructed air flow from
the ventilation slots on the base panel to those on the rear panel is
possible.