Omicron Lab CT Analyzer, User Manual

Page: 41 / 254

39
Setup and Connection
2.5.6 VT Winding Resistance Measurement Using QuickTest
To measure the winding resistance of VTs using the CT Analyzer , you can either
use the Quick Test function of the CT Analyzer (see chapter 8 on page 135) or
the CTA QuickTest PC tool which is part of the CT Analyzer PC Toolset .
Observe the general safety rules in section 2.1 on page 21.
For VT winding resistance measurements using Quick Test , connect the
CT Analyzer as shown in Figure 2-17. For a detailed description on how to
perform such measurements, please refer to section 8.8 on page 154.
Connect the "Output" sockets and input "Sec" of the CT Analyzer to the winding
to be measured.
Figure 2-17 Connecting the VT for winding resistance measurement using
the
CT Analyzer
2.5.7 Polarity Check Using QuickTest and the CPOL Polarity
Checker
Observe the general safety rules in section 2.1 on page 21.
For the polarity check using Quick Test , connect the CT Analyzer as shown in
Figure 2-18. For a detailed description on how to perform the polarity check,
please refer to section 8.5 on page 145.
1. Ensure that the ungrounded side of the CT winding is not connected to the
wiring to be checked.
2. Connect the black "Output" socket and the black socket of input "Sec" of the
CT Analyzer to that side of the burden that is connected to PE.
a
n
A
N