Series TCL-3M165E2
Safety Instructions
Technical changes reserved
- 9 -
2 Safety Instructions
Before you install the TCL-3M165E2, read through this operating manual carefully. If the
instructions contained within are not followed, in particular the safety guidelines, this
could result in danger for people, the environment, and the device and the system it is
connected to.
The TCL-3M165E2 corresponds to the state-of-the-art technology. This concerns the
accuracy, the operating mode and the safe operation of the device.
In order to guarantee that the device operates safely, the operator must act competently and
be conscious of safety issues.
OMEGA ENGINEERING provides support for the use of its products either personally or via
relevant literature. The customer verifies that our product is fit for purpose based on our
technical information. The customer performs customer-specific and application-specific tests
to ensure that the product is suitable for the intended use. With this verification all hazards and
risks are transferred to our customers; our warranty is not valid.
Qualified personnel:
The personnel in charge of the installation, operation and maintenance of the TCL-
3M165E2 must hold a relevant qualification. This can be based on training or relevant
instructions.
Personnel must be aware of this operating manual and have access to it at all times.
The electrical connection should only be carried out by a fully qualified electrician.
General safety instructions:
In all work, the existing National regulations for accident prevention and safety in the
workplace must be complied with. Any internal regulations of the operator must also be
complied with, even if these are not mentioned in this manual.
Ensure that the complete operating instructions are always available in excellent condition
at the calibrator installation site.
Degree of protection according to EN 60529:
Ensure that the ambient conditions at the site of use does not exceed the requirements
for the stated protection rating (
§ 10.1 "Characteristics TCL-3M165E2").
Structural safety in accordance with EN 61010-1:
The calibrator must be installed in such a way that the requirements for structural safety
are met.
Only use the TCL-3M165E2 if it is in perfect condition. Damaged or faulty devices must
be checked without delay and, if necessary, replaced.
If problems cannot be cleared, immediately shut down the calibrator and ensure that it
cannot be started up accidentally.
Never leave the calibrator unattended when it is in operation or in the cooling phase.
Do not remove or destroy type plates or other markings on the device, or the warranty is
rendered null and void.
