10 |
M 5 7 4 8
5
SYNC Configuration
Omega Link Smart Probe products are easily configured through
Omega’s free
SYNC configuration software. Ensure
SYNC is running on a Windows OS computer before continuing. Connect the SP-003/SP-004 to the computer using
your Omega Link Smart Interface to begin.
Note:
SYNC is available to download for free on the OMEGA website.
5.1
Connecting to SYNC - Automatic Detect
Once the SP-003/SP-004 and Omega Link Smart Interface are connected to the computer, SYNC will automatically
detect the probe and begin displaying readings.
Note:
If living readings from the SP-003/SP-004 are displayed on SYNC, skip ahead to section
5.2
Connecting to SYNC – Manual
If SYNC does not automatically detect the device, follow these instructions to manually connect it.
Step 1:
Click on the
icon located on the top left of the SYNC interface.
Step 2:
Proceed through the
Add Device Wizard
and click
End Device / Probe
.
Communication Interface
Set the communication parameters for the Omega Link Smart Interface that you are connecting.
Note:
The connection type and parameters must be accurate for a proper connection to be
established. Failure to accurately setup communication parameters may result in
communication errors.
•
Connection Type:
Select the type of connection you have between your SP-003/SP-004 and your computer.
•
Command Timeout:
The maximum time (in milliseconds) for a command to be completed before the command is
aborted.
Note:
The default command timeout is 500 milliseconds. It is recommended that this section be left alone to avoid
communication errors.
Figure 5: USB Communication Interface
Figure 4: USB Serial Communication Interface