M-5034/0611
PN: 11661-05 Rev. 0
Silicone Rubber Beaker Heater
Instruction Manual
INTRODUCTION
Thank you for purchasing a OMEGA
®
Silicone Rubber Beaker
Heater. Your heater is designed to provide a long and efficient service life with function, reliability, and safety in mind. For
successful operation of these beaker heaters, read and understand these instructions prior to use.
AGENCY APPROVALS
73/23/EC (Low Voltage Directive)
Approvals valid only when
installed in accordance with all applicable instructions, codes, and regulations.
IMPORTANT SAFETY INSTRUCTIONS
A person who has not read and understood all installation instructions is not qualified to install this product.
x
Do not immerse heater in
liquid.
x
Keep volatile or combustible
material away from heater
when in use.
x
Use heater only in approved
locations.
x
Keep sharp metal objects
away from heater.
Failure to observe these warnings
may result in electric shock, risk of
fire, and personal injury.
End User Must Comply to the Following:
x
Only qualified personnel are allowed to
connect electrical wiring.
x
Disconnect all supply power at the
source before making any power
connections.
x
All electrical wiring must follow local
electrical codes and highly
recommend following NEC Article 427.
x
Final installation / wiring is to be
inspected by the authority who has
jurisdiction in the area that the heater
is installed.
x
The end-user is responsible for
providing a suitable disconnecting
device.
x
The end-user is responsible for
providing suitable electrical protection
device. It is highly recommended that
a ground fault circuit breaker be used.
Failure to observe these warnings may result
in personal injury or damage to the heater.
x
Never handle the heater while it is in
operation; always disconnect the heater from
the power source and allow to cool prior to
handling.
x
Inspect heater before use.
x
Never operate heater without a temperature
control device.
x
Do not wrap the heater over itself.
x
If spillage of foreign matter onto heater
occurs, disconnect from power source and
clean after heater is allowed to cool.
x
Never operate a heater without an
appropriate heat sink (device being heated is
considered a heat sink).
x
Do not operate heater above rated
temperature value.
x
Fasten heater to device using approved
methods only.
x
Do not repair damaged or faulty heaters.
x
Do not crush or apply severe physical stress
on heater or cord assembly.
x
Disconnect heater when not in use.
Failure to observe these warnings may result in
personal injury or damage to the heater.
PRIOR TO INSTALLATION
1. Check for suspected damage to the heater like rips, punctures, etc.
2. Confirm voltage / wattage rating of heater is appropriate for power supply device or temperature controller. The heater
is designed to work at a specific voltage to heat properly. Failure to operate the heater at the specified rating could result
in overheating of the heating blanket, the surface being heated, or personal injury. Also note lower-than-rated voltage
will result in under-heating.
INSTALLATION
1. Wrap heater around properly sized beaker.
The heater must be installed with the wires exiting at the bottom of
the glass beaker.
