6
Installation Instructions
Please ensure that all power is switched off before installing the range hood. Installation must be in
accordance to the local electrical authority and codes. This range hood must be earthed at all times for the
operators’ safety.
The G.P.O. for the range hood should be positioned to enable the user to turn the
power off, to enable cleaning and any maintenance required.
Ensure that when installing the range hood, that it is protected from any possible
damage from tools etc.
Ducting for this unit must be installed in accordance to the local authority. Ensure that
the fixings used for this range hood are suitable.
Check the area where the range hood is to be fitted, to ensure that it is structurally
sound.
Before using the appliance, remove the plastic coatings protecting the stainless steel finish.
Ensure that the wall is structurally sound, and is capable of
carrying the weight of the range hood.
It is recommended that the dimension be checked on the range
hood before installing.
1.
The cooker hood should be placed at a distance of 65-
75cm (26-30inch) from the cooking surface for the best
effect.
2.
Drill a hole in the cupboard, 490*265(mm) for model
ORU50XL.
3.
Make sure the distance between the edge of the hole and
the edge of the cupboard edge is at least 35mm. Take
down the filter and remove the four screws on the panel.
4.
Use random accessory tighten screws fix the hood into
cabinet.
5.
Use 4 screws fix the panel into body and equip the filter.
6.
Install one-way valve: put the one-way valve into air outlet,
Put on the one-way valve with air outlet.
Operating Instructions
Note
: Before the unit can be operated, it must be ducted.
1. Push ‘Stop’ button, the motor will stop.
2. Push the ‘Low’ button, the motor runs at low speed.
3. Push the ‘Mid’ button, the motor runs at mid speed.
4. Push the ‘High’ button, the motor runs at high speed.
5. Push the ‘Light’ button and the two lights will be on.
6. Push it again and the light will turn off.
