3
Installation Instructions
The adjacent furniture must be able to withstand a minimum temperature rise of 50°C above the
ambient temperature of the room it is located in, during periods of use. The power supply to the
appliance must be cut off before any adjustments or maintenance work is done on it.
Preparation for Installation and Use
WARNING
: This appliance must be installed by an authorised service person or qualified technician,
according to the instructions in this guide and in compliance with the current local regulations.
•
Incorrect installation may cause harm and damage, for which the manufacturer accepts no
responsibility, and the warranty will not be valid.
•
Prior to installation, ensure that the local distribution conditions (electricity voltage and
frequency) and the adjustments
•
of the appliance are compatible. The adjustment conditions for this appliance are stated on the
label.
•
The laws, ordinances, directives and standards in force in the country of use are to be followed
(safety regulations, proper recycling in accordance with the regulations, etc.).
Instructions for the Installer
•
Fit the appliance into its surround (beneath a work-top or above another appliance) by inserting
screws into the 2 holes that can be seen in the frame of the oven when the door is open.
•
The rear panel of the cabinet must be removed so that air can circulate freely. The panel to
which the oven is fitted should have a gap of at least 70 mm at the rear.
•
For a built-in oven to work well the cabinet must be of the right type.
•
The panels of the adjoining furniture should be heat resistant. Particularly when the adjoining
furniture is made of veneered wood, the adhesives should be able to withstand a temperature of
120
℃
. Plastic materials or adhesive which cannot withstand this temperature will become
deformed or unstuck.
•
To comply with safety regulations once the appliance has been fitted it should not be possible to
make contact with the electrical parts.
•
All parts which offer protection should be fixed in such a way that they cannot be removed
without the use of a tool.
•
Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of
electric shock.
