omega altise
Water Drainage
When the water tank is full, the
WATER FULL
indicator will
illuminate and the compressor will stop working. A buzzer will
sound Pressing any button will stop the buzzer. You will need
to empty the water tank before the unit will work again.
Fig. 8
Before you empty the unit you will need to:
1. Turn the unit off and pull the plug out of the power supply.
2. Place a water tray or pan under the drainage port.
3. Remove the drain knob and rubber plug on the drainage
port and drain into the tray beneath.
4. Once drained, replace the rubber plug and drain knob into
the drainage port and tighten by hand.
5. Plug the unit back in and switch it on. The compressor will
delay restarting for three-minutes and then continue to
work as normal.
Important! It is recommended that you do not
move the unit around without firstly draining the
internal tank. If water is left in the unit then it may
spill out onto the floor or carpet.
Continuous Drainage
If you wish to operate the unit without the need to empty the
water tank, please:
1. Turn the unit off and pull the plug out of the power supply.
2. Remove the drain knob and rubber plug on the drainage port
and retain for future use.
3. Connect the drain tube supplied to the water outlet as shown
and locate the other end into a drain.
4. The drain tube may be extended by using a suitable
connector and an extension tube (OD: 18mm).
5. Plug the unit back in and switch it on. The compressor will
delay restarting for three-minutes and then continue to work
as normal.
Fig. 9
Please note:
1. The drain must be at or below the outlet level
2. Flashing comp/ ‘water full’ indicator will not function in this mode of drainage.
3. When the room humidity is over 85%, it may be necessary to utilise the continuous drainage method.
11
