OMEGA AIR B-DRY 1000, Installation And Operating Manual

Page: 12 / 65

12
TECHNICAL PARAMETERS
Operating pressure 4 – 16 bar
Operating temperature 1,5°C to 60°C
Pressure dew points -40°C (-25, -70)
Voltage, Frequency 230V, 50/60Hz
Power consumption <60W
Protection class (controller) IP 65
Noise level (at 1m distance) Normally up to 100dB(A)
Filter (inlet)* Super fine coalescing; residual oil cont. <0,01mg/m3;
0,01µm
Filter (outlet) Dust filter; 1µm
Input for stand-by STANDARD
Dew point dependent control OPTIONAL
*If dryer is supplied without inlet filter compressed air class 1 (ISO 8753-1) for solid particles and oil should be
provided to the inlet of the dryer.
DRYER RATING ACCORDING TO ISO8573-1
Solid particles
(1)
Water
(1),(2)
Oil
(1)
2 1-3 1
(1)
Typical result based on standard configuration and nominal operating conditions
(2)
Depending on the specific design, class 2 when operated at nominal operating conditions.
MATERIALS
Columns, construction, support Steel
Column inner protection /
Column and construction outer protection Epoxy painted
Desiccant support screen (strainer) Stainless steel
Valves Brass, aluminium
Sealings NBR
Fittings, Screws, plugs INOX, brass, steel (zinc plated)
Lubricant Shell cassida grease RLS 2
Outside protection Powder paint coated (Epoxy-polyester base)
Desiccant 80% Molecular sieve 4A, 20% Silica gel
PRESSURE EQUIPMENT DIRECTIVE
PED 2014/68/EU (Fluid group 2)
B-DRY 110 to B-DRY 300 Category 2, Module H
B-DRY 400 to B-DRY 1000 Category 3, Module H