8
For models with switch:
•
Set the switch at 0 (stop).
•
Disconnect the plug from the main supply.
•
Disconnect the grinding group from the motor assembly.
• Remove, in sequence, crown, plate, blade, and screw.
•
Remove the unwanted material from the inside of the meat mincer.
ACCIDENTAL STOPPING
If the machine stops accidentally during the processing operation, before investigating the reasons for this
failure, it is necessary to stop at once the supply of electric current to the motor by setting the switch at 0.
The electric flex should be disconnected from the socket.
After that:
•
If the stop is caused by lack of electric current supply due to a failure in the electricity network, do not
reconnect the machine to the socket until normal conditions have been restored in the network.
•
If the stop is due to overstress, disassemble the cutting unit after removing it from the motor assembly and
then eliminate the reasons for the stoppage.
•
In case the inconvenience is due to reasons connected with the power unit, contact the dealer to arrange
for the machine to be checked, if necessary, by the manufacturer.
DISASSEMBLING AND CLEANING
At the end of each processing operation, it is good to disconnect the plug from the socket prior to performing
any disassembling or cleaning operation after stopping the machine by means of its switch/reversing switch.
DO NOT pull the electric flex to unplug.
To remove the body from the power unit (or motor assembly), it is sufficient to loosen the hand wheel by a few
turns and extract the processing unit sliding it horizontally from its seat.
By acting in contrary sequence, compared with the assembling operation, it is possible to separate the
components and then perform the cleaning, washing and drying operations.
•
To wash, use only water (hot if possible) and neutral detergent for crockery.
•
When cleaning, never use acid or caustic products.
•
In order to maintain your meat mincer in perfect conditions for very long time, it is good to dry it accurately
(mainly its processing unit) after any operation of cleaning and washing.
•
If not using the grinder for a long period of time, a cast iron surface light lubrication will help to maintain the
working group in perfect conditions.
Operation
Maintenance