7
position 1.
•
Then load the meat to be processed on the hopper and feed it into the opening. Do this operation
exclusively by means of the pusher, but never by hand.
The machine consists of two main parts:
• A power unit or motor assembly, whose function is to supply motion, is equipped with an electric motor
with start/stop switch and power flex, drive and base to rest the machine on the workbench. Except for
extraordinary maintenance, which should be carried out only by the manufacturing company, no other
action needs to be taken. The only operations to be performed should be those connected with the
instructions for use.
•
A processing unit must be connected with the motor assembly in order to carry on its function.
PRELIMINARY OPERATIONS
Get the power unit ready by resting it on the workbench, then take the meat mincer body assembly to pieces
by completely unscrewing the threaded crown, then draw out perforated plate, grinding blade, and screw from
the body. We recommend that all the components described at this stage, also including presser and feed
hopper, should be carefully washed and dried. The motor assembly must not be washed.
IMPORTANT:
As the meat feeding opening in the body has been intentionally designed to prevent the
introduction of the upper limbs into a potentially dangerous area. By no reason should it be modified or
tampered with, the operator’s safety could be at hazard.
It is a good rule not to use the machine when it is empty to avoid useless wear of the cutting group. Therefore,
we recommend to stop the machine by means of the switch whenever the meat processing operation must be
stopped.
In case a foreign body, such as bones, skins, etc., should cause the machine to stop suddenly, the correct
procedure to be followed is the following:
For models with switch/reversing switch:
•
Set the switch /reversing switch at 0 (stop).
•
Set the reversing switch at 2 position for a very short time (1 or 2 seconds) providing to the loosening by
the reverse rotation of the worm.
•
Reset the reversing switch at 0 position to stop the rotation.
•
Disconnect the plug from the main supply.
•
Disconnect the grinding group from the motor assembly.
• Remove, in sequence, crown, plate, blade, and screw.
•
Remove the unwanted material from the inside of the meat mincer.
Installation
Operation