19
400715D-EN
2.
Remove the
mixing tube
[1],
mixing tube nut
[4],
collet
[3], and
O-ring
[1].
Figure 28
3.
If needed, replace the
O-ring
and clean the
mixing tube
,
mixing tube nut
and
collet
Remove the Nozzle Body from an A-Jet
WARNING
Do not install or remove the nozzle while the A-Jet motor on or active. Severe injury and damage to the A-
Jet may occur. Make sure the primary power, water, and air sources are turned off. Follow the lockout and
tagout procedures to notify others maintenance is in progress.
NOTICE
Failure to remove power to A-Jet actuators prior to removing the nozzle could result in damage to the A-
Jet assembly.
NOTICE
Handle the nozzle carefully to prevent damage to the abrasive tubing retention tube.
1.
Remove the
abrasive feed tube
from the
nozzle
and the
abrasive hopper
.
Figure 29
NOTICE
Remove the mixing tube BEFORE installing or removing the nozzle to prevent damage. Large upward
forces from an installed mixing tube can misalign the internal nozzle components.
2.
Remove the
mixing tube
.
Summary of Contents for MAXJET 5i 320303 Series
Page 32: ...32 400715D EN...
