10-004209-01EN [Q7750159], Rev. 2, May 2018
Operation
65
Figure 3
‑
11 Magnetized to surface
Avoid allowing the drive modules to slam into the inspection surface. This can occur
when all four wheels are not in contact with the installation/removal mat while the
SteerROVER is driven onto the inspection surface.
7.
Remove the installation/removal mat from the inspection surface.
Circumstance may arise when only one person is available for placement of the
SteerROVER on a inspection surface. With the system power off, it is possible to place
the SteerROVER on the inspection/removal mat and manually push the scanner off
the mat and onto the inspection surface.
8.
Align the front swivel mounts and umbilical mount to the appropriate
relationship to inspection surface (see Figure 3-12 on page 66).
TIP
TIP
Summary of Contents for SteerROVER
