10-004209-01EN [Q7750159], Rev. 2, May 2018
Chapter 6
206
Figure 6
‑
4 The Cycle Power screen—Scan Devices
When a device is connected to the system but is not detected, this most likely indicates
an internal device problem. Plug the suspect device into a different umbilical port and
perform the scan again to confirm the device is faulty.
Normal network speeds will be 2 for all devices. When a device is not operating at the
correct speed, the internal software attempts to correct the device speed.
When a device is not operating at the correct speed, it may disrupt communications of
the system network. Power should be cycled and the scan restarted.
Within normal operation, issues with device speed are very rare. Device network
speeds are set by the manufacturer and should not deviate.
Table 9 Common addresses
Common addresses
Raster Module
30
SteerROVER
40
TIP
Summary of Contents for SteerROVER
