10-004209-01EN [Q7750159], Rev. 2, May 2018
System Components
173
Figure 4
‑
109 Position primary and secondary probe holders
Because of the larger size of phased array wedges, scan results are generally
improved when pulling or dragging them.
3.
Mount the probe holder rack to the SteerROVER (see “Swivel Mount” on
page 110 for additional details). When mounting the probe holder rack, ensure
the attachment knobs are at the front (not the scanner side) [see Figure 4-110 on
page 174].
To avoid mechanical failure, the pivoting probe holder rack with four probes must
only be mounted directly to the SteerROVER scanner (see “Dual Drive Modules with
Pivoting Probe Holder Rack” on page 50). The raster arm is only able to support the
weight of a probe holder bar with two (2) probes.
TIP
CAUTION
Summary of Contents for SteerROVER
