Olympus PT-EP11, User Manual

Page: 37 / 156

EN 14
EN
Make sure the camera is loaded properly
Check the following points before sealing the Case.
• Is the digital camera loaded properly?
• Is silica gel inserted all the way at the specified location?
• Is the O-ring attached properly to the opening on the Case?
• Is there any dirt or foreign matter on the O-ring or the O-ring contact surface on the front lid?
Seal the Case
1
Close the Case gently while aligning the mounting projection of the rear lid and groove.
2
Turn the open/close dial counter clockwise.
• The Case is sealed.
3
Lower the ON/OFF lever.
Check the operation of the loaded camera
After sealing the Case, check that the camera operations normally.
• Operate the ON/OFF lever on the Case and confirm that the camera turns ON/OFF.
• Turn the mode dial on the Case and confirm that the camera mode switches properly.
• Press the shutter lever on the Case and confirm that the camera shutter releases.
• Operate the zoom dial on the Case and confirm that the camera’s lens is controlled.
• Operate other control buttons on the Case and confirm that the camera functions properly as intended.
CAUTION:
• If the open/close dial is not fully turned, the Case will not be sealed. This will cause water leakage.
Close
PT-EP11_EN.Book Page 14 Friday, November 22, 2013 10:54 AM