Olympus OTV-SI, Instructions Manual, Page: 132 / 174

126
Chapter 5 Operation
VIDEO SYSTEM OTV-SI
Figure 5.80
4.
Press the remote control switch for execution, the “Enter”, “

” or “

” key
on the keyboard to change between the record mode and record-pause
mode on the video tape recorder.

Using the remote control switch that is assigned to “VTR”
1.
Refer to the video tape recorder’s instruction manual, and set up the
record-pause function on the video tape recorder.
2.
Assign the “VTR” function to one of the remote control switches on the
videoscope or camera head following the instructions given in Section 5.9,
“Remote control switches”.
3.
Press the remote control switch for VTR to start the record mode on the
video tape recorder.
4.
To pause recording temporarily, press the remote control switch for VTR.
Record and record-pause modes are activated alternately every time the
switch is pressed.
VISY218