DMTA029-01EN, Rev. E, December 2017
Maintenance
65
6. Maintenance
The service requirements of the GLIDER scanner are minimal. Depending on
operating conditions, the GLIDER scanner parts might need periodic cleaning.
For parts adjustment and replacement procedures, see “Part Replacement and
Adjustment” on page 18.
6.1
Preventive Maintenance
The GLIDER scanner does not require preventive maintenance. Only a regular
inspection of the product is recommended to ensure that the GLIDER scanner
functions correctly.
6.2
Unit Cleaning
The GLIDER scanner’s external surfaces can be cleaned when needed.
To clean the unit
1.
Ensure the unit is turned off by removing the source of power.
2.
Disconnect all cables.
3.
To bring the unit back to its original finish, clean the housing with a soft cloth.
4.
To remove persistent stains, use a damp cloth with a soft, soapy solution. Do not
use abrasive products or powerful solvents that could damage the finish.
NOTE
Summary of Contents for GLIDER
