DMTA-10055-01EN, Rev. A, February 2015
Chapter 10
194
Figure 10-3 File name edit
Special characters such as spaces, decimals, slashes, and punctuation are not
permitted in the
Filename
field.
5.
For each of the next three optional fields (
Description
,
Inspector ID
,
Location
Note
) press NEXT, then
Edit
(P1 key) to enter information.
6.
If the File Type is
INC
:
a)
Press NEXT, then
Edit
(P1 key) to enter an optional
ID Prefix
.
This prefix will save as part of the ID but will not increment.
b)
Enter a
Start ID
for the INC file.
7.
If the File Type is
CAL
, press NEXT, then
Edit
(P1 key) to enter a calibration ID.
8.
Once you have completed the file setup, press NEXT to highlight the
Create
button.
9.
Press
Create
(P1 key) to exit the setup page and create the file.
Summary of Contents for EPOCH 650
